DIRIS Digiware D remote displays allow:
For example:
DIRIS Digiware D-50 and D-70 displays also act as a gateway, centralising measurements from DIRIS Digiware, DIRIS A, DIRIS B and COUNTIS E devices and making them available over Ethernet.
With the DIRIS Digiware D-70 display, data can be visualised on WEBVIEW-M, the "Power & Energy monitoring" embedded web server. DIRIS Digiware displays are 24 VDC powered.
Your single point of access to your entire DIRIS Digiware system
For applications without a local display, the DIRIS Digiware C-31 interface centralises all your system data and provides all this information to external software or a PLC via RS485.
The DIRIS Digiware C-31 interface is supplied with 24 VDC.
The DIRIS Digiware C-32 module is a bus repeater with a 24 VDC input that is used whenever the total power consumption exceeds the maximum consumption of the 24 VDC auxiliary power supply used. The C-32 repeater provides an additional 20 W and 100 metres to the Digiware bus.
A maximum of 2 repeaters can be used in the same system, allowing the Digiware bus to reach up to 300 metres.
The DIRIS Digiware M-50 and M-70 communication gateways are the access point for the DIRIS Digiware system, centralising the 24 VDC power supply and communication in one single point. The M-50 and M-70 act as the Ethernet gateway for all the devices connected on the Digiware or RS485 bus, and integrate a web server to configure the network parameters and to remotely display measurement data. The M-50 and M-70 gateways offer a wide.
range of functionalities, including:
The DIRIS D-30 is a remote display that can be connected to a DIRIS B power meter or a DIRIS Digiware I-4x current module via an RJ9 cable.
